Bull Ring Retractable Truck Bed Tie Down Anchors for Dodge RAM 2009+, Toyota Tundra CrewMax 2014-24, Hyundai Santa Cruz 2022-24, Rail Cap Trim Required to Install (2 Pack)

Great quality American made.If installing in a Ram , the easiest is to pick a warm sunny day Allow stake bed covering to warm thoughly.cut 4 sides to the width of the underlying stake pocket with a new sharp case knife. Remove the screws from the tie down . Install with the lip to the outside of the bed. Just be careful not to cut yourself or your truck.

Easy install. Used a razor knife for the cut outs on my 23 Ram 2500. Fits good and can’t wait to use them. This is the second truck I’ve had them on and they work great.

The anchors appear to be high-quality and very sturdy. I installed mine on a 2021 Ram 1500. I used a Dremel tool and a utility knife to cut the holes. I did not purchase the router bit and saw blade. On a Ram you essentially have to cut the cap holes as large as the holes in the bed underneath. Once I figured that out, the anchors dropped right in and were very easy to install. Very happy with the look!

Good solid product fits well. Needed to Dremel out the covers that where on my bed to install. Caution though don't over tighten them they will crack.

i have a 2019 Ram 1500 Classic. I have a foldable bed cover. We couldn't fit all of our luggage into the bed with the cover on it, so I purchased these, used my daughter's car top carrier and put the rest of the luggage on the top. These are very strong and drop down out of sight. I didn't want hooks that stay up and in the way all the time. These are very easy to install, very easy to use and VERY STRONG. 3 large suit cases for 12 hours straight at 80+ MPH. When we go to the Dunes next month these will be used to hold down my grandson's quad. I give my 100% approval. I will try to add a picture later. I didn't get a picture with the bag. June when we load the quads, I will add a picture.

Purchased the Bull Rings for my ‘22 RAM 3500 DRW only to find out afterwards they do not fit. Description says they fit RAM 3500, but way down in the fine print they tell you not duallys. Will be returning and looking for another brand that’s upfront about the product.

Excellent fit and finish. I had to cut the holes in the front bed rail cover and trim the rear, once that was done the install took just a few minutes and look great!For the front rails I drilled a hole in the bed rail cover centered in the square and then used a sheetrock knife to cut the square hole. On the rear there is a bit of a ledge that goes down into the bedrail, trimmed that out and install went great.Installed on a 2022 Ram 3500 Limited.

Although I did have cutouts in place for anchors. The plastic caps are too small and they required that I cut out the plastic in order to fasten the anchors. A little more work then I had figured but a Dremel tool and cut off disk made quick work. Have always used Bull Ring anchors they are very well made.