🏎️ Elevate Your Ride with Precision and Style!
The MOTOR METER RACING Classic 6 Gauge Set is a high-performance instrument cluster designed for gas-powered engines, featuring a digital odometer, Swiss stepper motor movement, and a sleek black dial with white needle illumination. This comprehensive set includes gauges for speed, RPM, fuel level, water temperature, oil pressure, and voltage, ensuring you have all the critical data at your fingertips. With easy installation and lifetime technical support, it's the perfect upgrade for any automotive enthusiast.
Manufacturer | I GAUGE TECHNOLOGY CO., LTD |
Brand | MOTOR METER RACING |
Model | Classic Series |
Item Weight | 4.35 pounds |
Product Dimensions | 16.1 x 6.8 x 8.8 inches |
Country of Origin | Taiwan |
Item model number | Electronic Speedometer |
Is Discontinued By Manufacturer | No |
Manufacturer Part Number | IG6GSETESPB-CG |
A**R
Works great
The Tac did not work but all the other gauges work well and look good. Seller sent a replacement gauge for the broken. Instructions for all the gauges were clear and easy to read.
H**R
Amazing Set of Gauges!
The media could not be loaded. I rebuilt all of the gauges in my 1965 Barracuda. All of the sensors that came with the set all work and all the gauges work the way they’re supposed to. I’m very pleased with the outcome of the gauges in the dash they look amazing and it still gives it that classic look that the 60s cars had back then.
T**T
Problems Problems and More Problems
This product is a fine looking set of gauges. In fact they are a fantastic looking set of gauges and they looked absolutely AWSOME in my custom built dash that I built specifically for these gauges. And that's where it all goes down hill. The tac is jumpy with poor response. I see others have mentioned that in their posts too. The Temp gauge quit working in one day. Also you will need to buy an adaptor for your temp sensor if you are installing in a GM product. The adaptor in the kit will not fit GM. Speaking of sensors. Read them carefully. Notice the Ohm range on these sensors are a little uncommon. Meaning use the sensors provided, you stock ones will not work with these gauges. Leading me to the fuel gauge, With an in tank pump this is a bear. They provide you with a cut in top load sending unit "Generic" however this would require you to cut your fuel tank. Folks if you don't know what your doing when cutting a fuel tank just don't do it. That can be extremely dangerous. Anyway I finally custom built a bracket connected to the existing fuel pump assembly. The pick up on the sending unit was not adjusted correctly from the factory. I had to bend the sending unit pick up rod so when the sending unit reached dead top the gauge registered full and when the sending unit hit bottom then it registered as empty. This is on the sending unit itself, I'm not talking about adjusting the float rod. The volt meter worked. The oil pressure sensor provided is very tricky to wire into a system that requires the oil pressure sensor to send a signal to the fuel relay. Once again generic or OEM sensors will not work with these gauges. I am so sorry, I swear I'm not one of these trolls out here bashing stuff, in fact I rarely write a bad review. In this case, It is what it is. I cannot recommend these gauges even to worst enemy.
B**8
Works well but tachometer is useless
Used in a classic truck and all gauges except the tachometer work very well. GPS speedometer is accurate and wiring was easy.I think the tachometer is for use with a newer vehicle because from what I have seen you can't just connect it to the negative side of the coil.
J**J
Look good
Bought two sets of these for two different Harley's. Customer support sent video to assist with setup. Gauges look really good!Fuel gauge requires adequate voltage to read properly, sending unit works well.Tachometer works pretty good once you figure out the setting for it. Two cylinders are challenging but I’m sure standard 4/6/8 and two stroke boat motors etc would be perfect.Best way for customer support is contact through Amazon seller.Seller corrected all little issues via email.
A**R
Professional seller!
Very nice looking gauges
K**N
Tach setup issues
Setting up gauges is generally pretty basic and easy. All the gauges work well including the fuel sending unit. However, the Tac set up is complete junk! holding the back button down for three seconds gets you into the set up. You need to know the Exact frequency output your engine is producing, then attempt to calculate what H setting you need. My signal wire is coming from the coil, and the Tac basically doesn’t work at all. The instructions are horrendous and don’t supply calculations for the H value.Very disappointed after I drilled a hole in my dash and now I have to look for a new Tac that doesn’t match the other gauges. The entire reason I bought this set is so all my gauges would match. Super disappointing.
S**N
Good looking
Very easy to wire up. Install was straight forward. Have not tried them yet. Excellent value so far.
Trustpilot
2 months ago
3 days ago