Yakamoz Set of 2Pcs Bevel Stile and Rail Router Bit Set | 1/2-Inch Shank | 7/8-Inch Stock | 3/8-Inch Cutting Depth

It arrived with no shims. I used it once in 2020, but had other issues with my stock. I got back to these again, and still have problems. The cut needs adjustment, and according to the instructions, shims need to be removed. But there aren't any shims to remove, so I cannot adjust the bits. Niw I have two purchase another set, but from another company. I'm also getting a lot of edges where the to layer of fibers is not cut sharp. I would have to sand all of the faces flat, we're I to use these. It's not tear out, just not a sharp edge. Face and back. I built 6 doors in the fall. They should not be dull.

The set cut fine, but the center groove and corresponding tongue do not match. The tongue was almost 1/16th" thicker than corresponding groove. Had to run the groove tool through twice, adjusting for the difference - which led to a sloppy joint. I got the project done that they were purchased for, but with great extra effort and less-than-hoped for results. Cannot recommend this brand.

I got these to build som cabinet doors. The profile is very basic, but looks great with the style cabinet I built. The profiles go together well. It comes with a spacer, and make sure you keep track of the spacer as it is necessary to make the joints fit correctly. My only complaint is that the the bits don’t stay sharp long. I ran about 50 linear feet of rails and the bit is dull

These are the first cuts I made with these bits (unfortunately after the return period). The cuts are EXTREMELY rough and the bits burned all the way through. I don't know if I was sent used bits or what. The cuts you see were made on a table with a coping sled. I even tried 2-3 passes to lighten the load on the bits. Same result. Plan on spending your savings on sandpaper to make these cuts look like anything. They match perfectly and the post-sanding joint is passable. With the amount of time spent planning, cutting, planing and finishing your cabinets, save your time and buy better bits.

Those of you that will use this type of bit set would appreciate bits that allow for the wood to interlock on the first pass. This set requires that you move bit for a second cut in order to not force pieces together. On your table router that isn't that big of deal but when you have a lot of end cuts it adds time. Okay for the price but not precise.

I used it on pine and they work great for 3/4” material!

It cut like butter. I Used it to make a Dutch door for my wife she shed . I was making a slot for panels in the door.

I'm pleased with this set of bits. They provided a clean cut on poplar and the joints are tight. I didn't have any of the issues others have mentioned in their reviews.