Multifunction Scribing Tool - Precision Woodworking Scribe for Carpentry, Contour Marking, and Construction - Measuring Tool with Durable Design - Metal, Stone, and Woodworking Scribe Tool

Just here how to answer the question that was difficult to find. How do you flip, switch, change the direction of the center piece so the pencil is closer to the accurate, thinner tip? You move slide the center piece to the middle, and pull apart the flanking plastic sides apart so it falls out.This was also mentioned in the manual but I seemed to have overlook it.

Life saver for doing trim against a tin ceiling

Made things easier to get a rough template made for boat bulkheads on sailboat. I will be using it a lot in the course of boat rebuild.One con: Markers or Sharpie pens will not fit in holder, pencil is not always satisfactory to mark bulkhead.

I got this to scribe boards against an uneven concrete floor. But before I got to do that, this nifty little tool proved itself useful in ways I hadn't thought of before. One was to give me a level gauge to use with a laser level, to find a level contour on an uneven floor. The shiny brass wheel-nut that tightens the pencil clamp also does a great job reflecting laser level light. So I adjusted the height of the nut to match the laser, then ran the tool over the floor in various places, riding along on its skate wheels until I found a spot with matching depth, marked it, then moved over, repeat, until I had a contour line.Of course, you can also use this to scribe boards. The hardware parts are all good quality and the plastic the thing is made of seems robust, durable, and well molded. The height adjustment works smoothly at the touch of a finger, yet holds firm through use (this is the essential function of the device). I paid 2x or so what I could have paid for one of the cheap Chinese knockoff versions of this thing that Amazon also sells, but I feel good about the quality I got and am happy to reward the people who created this clever design.

This is the only scribe tool I found that works at a right angle to both surfaces, so I paid the high price. It should do that very well however, when I followed instructions to reverse the tool holder to the non-roller end, the adjustment tab broke off. I could live with that except that the two prongs that provide a slight angle needed to bear down on the pencil, are also attached to that tab. So, if you can use it right out of the box and dont need to make that change, it may well be worth the cost to you.

takes a little getting used to but after you use it a couple of times its amazing

Muy práctico me sorprende lo único que es muy costoso

Me gustó