Wall Mount Lumber Storage Rack and Garage Shelving, Wood Organizer, 4Pack Holds Up 1200 LB with 3-Level-Indoor and Outdoor Use,16.7 x 12.7 x 1.2 Inches, Red, HMBJ001R-4

Heavy built shelves to hold wood for your projects. These are red, although they are available in a few other colors. They work great for a small shop to help control some of the clutter. If you wanted to use them for wall shelves, simply hang them and place some 1" x 12" boards on them. Rated for 600 lbs, they come with the hardware needed to hang them.

Needed something quick, low cost, and easy for some trim storage. These racks came fully assembled and with mounting hardware. I haven’t tested the stated 600lb weight rating, but I’m not going to load this system up with that much weight. The welds are quite small, but the racks are straight, and quality for their price. Being light weight, I’d consider these racks more for organization than pure material storage.

I love these racks. They are super easy to mount, just find a stud drill a pilot hole, and attach with the included lag bolts. Now you have a very sturdy wall rack for lumber, pipe, conduit, etc. Throw some 1x across it and you have a heavy duty shelf. Or even just hang heavier items from the arms. The options are endless. And the finish is nice enough to be used in the house or garage/shed. I have a few similar sets already and I plan to add some more in the future. Organization is the key to happiness.

This was a great case where I looked at these for a while, but never pulled the trigger, and I wish I purchased these earlier.This rack set worked great, very sturdy and elevated my wood out of the way and storing it flat. The provided bolts were solid and hold the weight when properly screwed into my studs.I popped a picture in so you can see them before I installed them on the wall.Great performer, and I am happy with the purchase.

These lumber storage racks have a nice finish. When I hung them all three shelves were level according to my 4' bubble level, so the arm angles were manufactured with consistent alignment. I used the lag screws and mounted them into the 2x4 studs behind the pegboard in my garage. I tightened the lag screws by hand and tried not to overtighten them so I wouldn't strip the wood. After looking them over, I decided to move them higher up the wall. When I took them down I was surprised to see I dented the frame where the screws go through to the wall. I should have photographed the dents before I remounted them because the denting would have shown up better, but I didn't think of it at the time.When I remounted them I used washers under the screw heads. Washers do not come with the package, but I highly recommend using them as I think it would prevent the denting because the pressure would be spread out farther and more evenly. Even with the screws denting the frame, these are still pretty nice, especially for the low cost. I'd get them again if I needed more—I'd just use washers the next time. :)

I bought these shelves for storing lumber on my garage wall. They say they hold 200lbs per shelf for a total of 600lbs total. I have to say, they are so much smaller than I expected. I guess I should have looked at the dimensions better before I purchased these. They are only about 16.5" total height and 6'5" in between the shelves. I have no doubt they would hold the weight, there is just not much room between the shelves to store any lumber that heavy. The tubular steel is thin and the shelves themselves do not look all that study. The plastic cap on the ends is not thick either. I can fill them up with 16" 2X4's and I think my total weight is approximately 100lbs. Other than that, they work great if you have a few boards that you want to get up and out of the way to put up on a garage wall. I suppose you could also make heavy duty shelving with them. I would buy again, but I think I would need more of them for longer boards. Nice looking black finish. Make sure you center the braces on a stud and you are good to go. Inexpensive is a plus. And you can store up and away off the floor of your garage or wall. My main complaint is that I just wish they were much larger and more sturdy.

The shelves have a smooth and well-crafted finish, and they appear to be of high quality. I made sure to mount them into the studs of my wall because I have concerns about anchors holding as much weight as these shelves can. In my opinion, these shelves are not only great for saving space but are also a reliable and sturdy choice for securely storing wood.

I needed some extra shelf hangers for my lumber and these worked perfectly. Great addion and I now need more. There are no cons, they will hold the weight.if I had to pick a con, it would be they could be larger in depth and maybe 2 icnhes more apart. Other than that, these are a great addition to your workshop.