VEVOR Electric Hydraulic Rebar Bender, 1500W Portable Rebar Bending Machine, Bending up to 3/4 Inch #6 (6-20mm) within 4 Seconds, High Power Steel Rebar Bender w/Tool Case Oil Can,Black Blue RN-22

Pretty happy with it. Bends 5&6 very easily and quickly. I have not bent #3 or 4 yet and I think it needs to have a piece changed to do smaller bendAs some other similar tool reviews not, be aware that this will bend #5 and bigger in a too small of radius for the code. These should have a 6x bar diameter radius and it will end up a little smaller if you do a full 90 bend without an adjustment. The workaround is to bend to about 60 degrees, release the bender and move the bar about 1/2” and bend again. You’ll end up with a code compliant 90 bend for large bar diameter rebar. Bigger bar like 7 and 8 will probably need more finesse. Still very fast and a time and money saverTool seems very rugged. I have a BN cutter and this complements well. I will make stirrups soon and think it will go well.The box / case is a nice touch albeit very thin cheap feeling that will dent up quick but better than no case and so far it’s held up.

Worked great. Made 150, 90 degree bends in about an hour. I wish it had some kind of stop to get repeatable angles.

Working great so far! using in a small fab shop to bend reb and DBA for Embeds! going to try and mount to a table and set up a foot peddle !

Still using this unit 1yr after it was initially purchased had to refill the hydraulic for the first time yesterday and believe this was my fault for storing in correctly

Worked well. Used it on #6 rebar. Made atleast 60 bends without hesitation.

Really sturdy construction and at a good cost relative to other options. While it says it can bend #1-7 rebar at 90 degrees, it isn’t accurate out of the box, seemingly not accounting for the spring back that always occurs. Tech support has been super responsive, and has offered a part to correct for this. While appreciated, ideally the design should just be fixed to avoid the need for the part. Would still buy again, but be aware.

We bent all the #5 bar for a county concrete boxed culvert replacement job and it has worked very well. Fast and easy even running off the generator.

Bought this machine bend stainless steel round bar was a little concerned being it’s a rebar bender but it works great only used it for about 20 min. Gives good radius but leaves nasty indents in material