Chrome Body Side Trim for Chevy GMC Blazer

Cleaned mating surface, measured and cut, peeled back adhesive and applied. Started to come off following day. Might try again with better adhesive tape and after I lay molding down so it stays flat. It had a memory from being in a roll and that is why it didn't want to stay on.

Many products like these are out there for grabs. The problem is that one doesn't know which one to get and trying to get one that it is not expensive. A lot of sellers out there in the market have marked up high when it comes to these 90's truck. I like my truck but one needs to know when it is good to buy expensive and when it is better to buy on the affordable side. The tape is holding so far and has not come off. Then again, like many out there who have this truck it is now driven on a daily basis and it is garage kept. My truck is a project car so I do try to keep it stored away from the elements. The molding looks really great compared to the old molding. Does add a better touch to the truck. Material is very strong and not very flexible. I don't mind this as I want it to not flex at all. The hardest part is cutting it at the right angle. I am particular about this so it may not matter to the next person. Compared to other sellers, this is not that bad. I am satisfied and so will you. Get this and you will not regret it one bit.

Arrived well packaged and speedy delivery. However, when opened - much of the adhesive foam mounting strip is detached and maybe shrunk a bit. Not sure if is from the hot weather it was shipped in, or, a fault of the design / mfg. I'm attempting to reposition and re apply the strip adhesive and will update this review after I actually try to install on the truck. Hope it works out as it looks really nice.

I know it says 88-98 but this is the same trim used on the 99 GMT400 Suburbans.My old trim had started lifting in certain areas and the plastic layer on top of the chrome layer had turned yellow and disintegrated. I was able to get all the old trim residue off with an eraser wheel and cleaned everything with isopropyl. This new stuff went on easy and I didn't use anything but the adhesive included (pre-installed). Roll had plenty for both sides of the full size sub and I think it looks great.Time will tell how it holds up to UV and such, but so far so good.

The double sided tape was coming off and not applied correctly highly disappointed I returned it.