Dorman924-066 Body Mount Compatible with Select Ford Models

My husband installed these on his 2009 F-250 Crew Cab. Installation was fairly straightforward. No interior access to the vehicle in needed—if the bolts release from the cagenuts.Restored the trucks OEM ride characteristics and handling.They are silent—no squeaks are present—although he coated them in silicon grease, hoping to preserve them for the heat here Texas and to prolong their service life. He also applied a rust preventing thread compound to the new bolts to prevent seizing and galling.Bolts were torqued to the recommended 86 ft/lb.

I replaced all body bushings on my 2009 Ford f250 super duty super cab. This unit replace all positions except the two front ones near radiator. Heated up bolt heads on old units and was able to unbolt 3 of 4. Passenger side foot one gave me trouble I was able to loosen but then cage but started spinning. I would advise to use breaker bar and loosening and tightening to clear threads that are exposed above cage nut. It takes awhile because of all the threads but it's much better than replacing a cage bolt like I had to on one. Probably best to replace the whole side if you are doing one. You need to jack up the body a few inches anyways. I had to drill, use a Dremel with a cut off wheel and hammer with cold chisel to open up the old cage washer enough to get new cage nut and washer in. It's tricky to start by yourself but it's doable. Tightened to 86 foot pound.

Mounted these on 2011 F250. I originally purchased the polyurethane kit sold on Amazon. The cab would bottom out and bang against the frame over large bumps. The polyurethane mounts are very hard as well, and every vibration is sent through the cab.These Dorman mounts are more expensive but are well worth the price in my opinion. My truck is smoother and more quite with these and the cab doesn't bang against the frame anymore.

I asked the question if the bushing is black or yellow, and the response I got back from a party on this board was black as pictured. Clearly it's not black. It seems much softer than I was expecting.

After much research I went with the Dorman replacements for the radiator support mounts. 5 years later I replaced all the other mounts with Dormans replacement mounts. These are solid rubber instead of foam and ride very well, though I cannot speak to the ride quality of other solutions.I did notice the new bolts on the radiator support mounts I had replaced had rusted badly, so I kept the stock bolts for the other 6 mounts since they had rusted very little. Also, some of the rubber seems to have run out of the molds during manufacturing and must be cut off for the mount to fit smoothly but it takes minor effort to do so. Over all very satisfied with the purchase.

Back to having a smooth quiet ride with your product.

Fits perfect factory replacement

These fit my F250 great and better than the factory ones