iLiving 14" Wall Mounted Shutter Exhaust Fan, Automatic Shutter, Temperature and Humidity Controls with Variable Speed, 1200 CFM at 1600 RPM DC Motor

I purchased this fan to pull heat and cigar smoke out my garage. I installed it inside the wall. Took some time cutting the drywall and stucco on the outside. But overall, I am glad I did it but if I had to do it again I would hire someone to put it in. The fan move air pretty good. I smoked two Cigars last night. I place the timer for 1 hour after I was done for the night the next morning, I could not smell any cigar smoke. The timer is easy to use and the programming is pretty easy as well. I added a frame around mine and hid the cords. Not to noise but there is different fan speeds to quite it down

I recently installed the iLiving 12" wall-mounted shutter, and here's my quick take:Performance: It improves airflow but isn't strong enough to cool my garage on hot days.Speed: The fan operates adequately but could be faster for larger spaces.Size: Compact and easy to install in tight areas.Noise: It produces noticeable noise, which can be distracting.Value for Money: Decent value for ventilation, but consider additional cooling for extreme heat.Overall, it’s a good choice for improving ventilation but has limitations in noise and cooling efficiency.

Cools my hot garage well and love the temperature control.

S fan works as described. My only complaint is the digital readout is dark and hard to read

I really didn't have any issues during the install process. Once you have your hole cut to the correct size, the rest is just electrical. Then just plug it in and go. The thermostat controller works well and is easy to configure. The thermostat does blank after few seconds, but pressing any button brings it back. I guess it is for saving power, but not sure that is necessary since the fan unit uses 110 VAC. I am probably going to buy the larger unit for another building I have.One minor complaint is that the max. temperature setting is 99 degrees F. This should be fine for most applications, but worth noting.One surprising thing was the lack of including 8 mounting screws. I guess they were assuming that mounting the fan is unique for each user. Not an issue really, but you will need these screws to complete installation.

Bought this to replace a passive vent in garage attic. Old vent was bigger, had to frame around existing hole in wall inside and out to bring to appropriate size. After that installation was easy, just set it to auto & it turns on & off as needed. So far it's quiet, working well, temperature in attic way cooler..I should point out I have a screened vent on opposite side of attic, so fan draws fresh air across attic & exhausts..Had a couple of heavy thunderstorms, no issues with rain..Attic is 800 sq.ft, fan is 12 inch

This is a powerful exhaust fan. I haven’t fully hooked it up yet, but have mounted it and plugged it in to run a test on it. The louvres were stuck in the closed position and I had to get up on a ladder to free them.

This is exactly what I was looking for. Easy install especially into a metal building. I did not have a ridge vent on my building so I use this instead does make a difference relatively quiet and I like the ability for the automatic function