VEVOR Beach Fishing Cart, 300 lbs Load Capacity, Fish and Marine Cart with Two 13" Big Wheels PU Balloon Tires for Sand, Heavy-Duty Aluminum Pier Wagon Trolley with 8 Rod Holders for Fishing, Picnic

Great beach/fishing cart after reading some reviews I also made some modifications to make life easier.1) I used lock tight on all the bolts holding the frame together so they don't walk themselves out.2) I added a bolt and wing nut through the frame and Axel to keep the axel on since the only thing that was holding it was a push pin lock. (Used wing nut so I can remove it for easy transport and storage).3) added wing nut and bolt to where the handle bar attaches to the cart so I can remove the bar easily for transport and storage or tighten when needed.4) I used corrugated plastic to make a floor board and walls. Utilized the fishing rod holders to hold the walls up and then used zip ties to fix it the the frame at the bottom, sides and top. Easy to replace if needed and inexpensive. Will come back after summer for a 3 month use review.

Very nice little beach buggy, I love the big inflatable tires that will go over everything and it's a good size to carry a cooler and extrasIt went together very easily.Took me ten minutes to assemble. I think it took sixteen screws to put the frame together and an additional sixteen smaller screws to put the fishing holders on.Is the only complaint I have Is is the axles that hold the tires on fall out very easily. When they fall out , your tire goes right off the buggy.I guess the axle locks that come aren't very strong and they come out of the hole pretty easilyPretty easy fix what I did was.Just drill a hole through the frame and through the axle tube and put my own screw and nut securing it. I added pictures So you guys know exactly what i'm talking about.

The tires are very robust and should have no problem going over beach sand . Plenty of room for my tackle box, live bait bos and cooler. Plus a beach chair or two. Plenty of rod holders. The cart is well made with painted steel ( I'm guessing). All fasteners are stainless and takes about an hour to assemble. The only problem I had is my surf rod butts slide all the way threw holders. There are no screws supplied at base of rod tube to prevent rod sliding through. I added 1.5" stainless screw with nut to hole at bottom of tube. Works fine and prevents rod from sliding through.Update!After using the cart for several months I find it easier to push rather than pull it. Also the cart upper and lower frame started to rack. They are only joined at the rod holder tubes. So I modified mine with 1/8" aluminium plate on each side. See pics. This strengthen it solidly, now no flex at all. Note To Manufacture.

very awkward to haul. the handle to "drag" the cart is shaped very weird and it makes it hard to haul a fully packed cart. i am going to have to re design it somewhat myself and alter the handle with an aluminum bar. the wheels are OK'....ish. they are listed to have 3lbs air test. at that low rating the wheels remain weirdly shaped and not perfectly round. they have imperfections and hence when you roll the cart is doesn't roll smoothly. will not recommend

easy enought to put togetheras to longevity.....I have serious doubts.upper frame is held to lower frame by 7 pole holders. One fixture point on top and one on bottom x 7 holders. Plus one more in front for tow bar. These 8 points do not provide long term fixture.As you put in into and out of vehicle, you will stress and bend the fixture points. Also just draging it over uneven terrain will do the same.With anything near the rated load....200 pounds.......you are gonna twist and bend and break things.I surf fish for halibut up here in alaska and it can be 1/2 mile down to water with 20 foot tides.will update after a few trips.up date after 4 tripsrod holders had to be modified because the ends of rods dig into sand and rocks when rolling cart. No endstop to holders so you have to put a pin in for transports....minor modifications BUT.you will be strapping everything down other wise you will leave a trail down the beach from lost itemsfood and bait coolers fit nice and stay with out straps but clothes chairs etc need help.

Everything about this cart was 1st class, I was very impressed. From the packaging ( carefully wrapped, small parts seperatly packaged and labeled) the clear instructions, the materials used and all parts lined up perfectly during assembely. Even all tools needed for assembely and an air pump! In a time when i've come to expect the least from items purchased on line,this was a pleasant surprise. Well done Vevor, keep up the good work!