4 inch Ceiling Fan LED Light Replacement 3000K, 18W 2000LM LED Retrofit Kit, Bright Round Ceiling Fan Light Kit, 120V, CRI90, Dimmable

I used this module to replace the LED in a Minka-Aire Dyno ceiling fan. The "official" replacement module for these fans is expensive and hard to source, so I was motivated to find something better. Fortunately this module was great. To replace the fan's module, I had to take the old light assembly out and fully disassemble it. It was tricky to get the plastic off; I ended up needing to cut a notch in the edge of the plastic cover and then heat up the plastic with a hair dryer, which barely allowed me to jam a screwdriver in and work my way up to a putty knife, which finally popped the old LED module out. I disassembled both modules, swapped just the circuit boards, and cut the leads off of the old module. I used the wire nuts included with this module to attach the old module's wires to the input wires on this module and reassembled the whole thing. It works great.The only issue I ran into, which is entirely my own fault, was that the capacitors on this module are slightly too tall to fit inside the plastic housing of the Dyno ceiling fan LED module. This module is very thin so there's not much space at all. However, it was so close to fitting that you can't really tell that the plastic cap isn't fully seated, so it's visually fine anyway.This new module is brighter, more efficient, and has better CRI than the original, so I'm very happy with it.

Converted my Florissant tubes in my kitchen to these LED. I have beautiful round kitchen lights, but each light takes two curved light tubes that burn out about every year and a half. This LED was easy use and covert my old light. I’m not an electrician, just normal a round the house guy. If you can install a ceiling fan, or wire an outlet you can install this! Nice and bright in my kitchen using daylight LED.

Installed well and worked. But very dim. I guess I assumed because it was for a ceiling fan that would be bright, but it might be my fault for not looking at the power.

Replaced the 4 lights under an old fan with this. Did not like the original 4 bulb assembly that came with the fan many years ago and wanted to change the lights to a small LED source and control it via Alexa without getting out of my chair as the daylight coming in the window changed in the evening.1st picture shows old assembly. Took the light kit off, removed the arms with the lights, added a Wi-Fi Wireless Smart Switch compatible with Alexa inside where the arms used to be, attached a round magnetic plate to the bottom and ran the wires down to the LED.2nd picture shows the after. Works perfectly but do wish they made an optional diffuser lens to replace the clear one it come with.3rd picture shows the camera darkens when taking a picture with the light on. It’s a bit bright even on the lowest setting.The 4th picture is from 6 ft away and even then, the camera is affected by how bright it is. Trying to diffuse it some with different methods.Last comment - They would likely sell more (even if they increased the cost) if they sold an optional diffuser lens to replace the clear one. All in all, very happy, ordered another to do another fan just like this one.

The lights work and are nicely adjustable for brightness and warmth. Just note that even with the light turned off you will get a little bit of light production when the fan motor is running (at least I do, and the faster I run the fan the brighter the light). It isn't enough to keep me up at night and I'm quite particular about having my room dark.

Said it was compatible with my fan and is clearly not wasted time and money

Easy to assemble and works great.

Arrived early. Works fine. Very bright..