WINOMO2pcs Flash Strobe Controller Car Flasher Module for Brake Light Tail Stop Light

Easy hook up and worked great on my 07 Camry brake light. I don’t think it works if the light bulbs are not LED

Added to my daily driver. The hardest part was determining +/- and that wasn't hard at all. I used blade connectors so it van be bypassed or replaced later if needed.

Comes with two modules. Not sure why, but a good deal. Installed on a 2017 Ford CMax high mount stop lamp with 5 incandescent bulbs. After installing, it was only able to power one of the 5 incandescent 5W5 bulbs. That;s fine if you have a motorcycle with one incandescent bulb. I needed all 5 to work. Easy fix. I purchased ATO 194 six LED Bulb 3030 Chipset 2SMD T10 for $9 off of Amazon. I was careful to make sure the bulbs were seated properly and as noted in the led bulb instructions, I had some led lights not work. You then have to take the light out, turn and re-insert. Simple and everything is working great! 4 quick flashes, followed by 4 moderate flashes, then solid until you let off brake. Hopefully the module will work a long time! If it does, you won't find a better deal out there.

Good high center brake light flasher. I installed one on my Avalon the other on my MR2 Spyder. Works well on both vehicles. On the Avalon I had the original tungsten light bulb, the reason it is 4 not 5 star is that with the initial tungsten bulb the first three flashes go so quickly the bulb does not respond quickly enough, the second 3 flasher happen much more slowly and worked well. I switched it to an LED bulb and it works much better with the first very fast flashes.Too early to know about long term durability.

The media could not be loaded. Two for the price of one, easy to install works as described.

2 units for $10! Easy to install (once you know what wire to cut - check your service manual!). I bought these units for my two motorcycles. I had one previous from a friend that gave me one of his. It was very easy to install and does what it says. So I bought the 2-pack as I have another motorcycle and figured to keep the extra as a back-up.The pattern is: when engaging the brake it strobe-flashes, then slower flashes then brake light is on. I've always used the Signal Dynamic "Back-Off Brake Light Modulators" and, when they work they're excellent. The problem I've had with them (on numerous occasions) is when installing, if the power touches ANY part of the bike it will short-out the entire unit! And at $40 a pop that can get expensive. Also, the "Back-Off" has a different pattern where it blinks 4 times, then steady-on, then blinks 4 times, then steady one, etc...This module does what I stated above so if you want a constant blinking I'd suggest going with another module or brand. But for $5 a unit this is hard to beat!***Make sure you have LED light bulbs! My 2007 Ninja did not have them and needed to be replaced. Wouldn't work without them.

Very easy to install and work great with LED high mount stop lamps. I cannot prove that these have prevented any rear end collisions, but I can tell you that since adding them to each my vehicles after having two cars totaled in four months by distracted drivers who rear ended me I believe this is cheap insurance that adds an extra layer of protection and catching the drivers attention behind you.

It worked good for 2 years then is stopped working, either soldering came apart or board broke inside.When pressure is been applied on marked area then it works.Scotch tape is something else, make sure to buy 3m double tape to replace it with the one that it comes with.

Working as discribed

I have used these on the brake lights on my motorcycles and my truck topper brake light. All these lights have been led so I don’t know if they will work on ordinary bulbs. They flash the lights about five times and then go solid. They definitely catch the attention of vehicles following you and I believe avoids rear end collisions. I have had these on vehicles for three years or more and never had one fail. I would definitely recommend them.

Baught a pack of 2. One worked, the other did not. $7 for 1 isn't bad, but now I have to buy another 2 pack and hope I have the same or better odds.Edit: After almost a month, the one installed crapped out and would continuously flash while I was holding the brake. Removed it and trying another style.

The media could not be loaded. Installed on motorcycle and car. Works great and you can’t beat the price.

Installed and works perfectly on an LED taillight. Several fast flashes, some slow then steady on. Eye catching. Can't vouch for longevity but it works in a warm garage during install. Hopefully it lasts, if not I have a spare or a freeby for a buddy. Youll need to figure out your own wiring, no instructions. If it lasts you can't go wrong for the price!