STICKGOO Wave Wall Panels for Interior Wall Decor, White 3D Wall Panels Accent Wall, Paintable 3D Wall Decor Covering Panels for Living Room Bedroom, Pack of 12 Tiles

I purchased these tiles to install in the toilet room on one wall. The wall is not a straight wall as it has a curve in it which is where the challenge occurred. That was one problem. The second issue was the glue. The manufacturer recommends 2 certain adhesives but I ended up trying 4 different ones obviously at my expense and ended up using the Gorilla Construction Glue - Clear version It is about $15.00 a tube, but well worth it. You apply it to the tile, wait a few minutes then apply it to the wall, hold for about 30 Seconds to a minute and it stays. Also, because it is clear, any glue that comes through the sides you can use your rubber glove ( disposable ones) to smooth it into the seams or the best option I found later on when I did another wall using a different style tile was using the foam application swabs - they work great. The first 4 different glues that I used, 1 was grey, one was dark gray, one was white - The grey ones were good but if the glue came through the seams, it was not a pretty sight and trying to clean it off was not easy as all of the adhesives that I tried were construction glue, the white one was very liquidly so I ran all over the place except where you wanted it. The 2nd issue was with installing these tiles on a curved wall - my advise, avoid it if you can - it caused a delay during the installation as when I installed the tiles, I had to secure each tile temporarily to the wall using small screws and washers to keep the tiles in place until the glue dried in an hour. Due to the curved wall issue, this 8ft x 10 ft wall took a few days to complete, but in the end, looks great. Now, for cutting these tiles, I found that using metal shears works the best. Trying to cut these with a utility knife is hard.

Easy to assemble on a wall, holds well with gorilla glue. Great look, great value and quality

I really love this product! It was very easy to install and the result is better than I had hoped. The tiles are large, so each one covers a good size area. They are made of plastic which makes them lightweight. I used liquid nails to glue each tile to the wall. I also put a small finishing nail in each corner to secure each tile in place. Cutting the panels is somewhat difficult because of the large textured pattern. However, if you use snips, and take your time, you won’t have any problems. The only issue I had was cutting out the area around the wall outlet. I did get it done but soon realized that I could not put on the outlet cover because of the raised pattern of the tile. I’m sure there must be a way around this but since it was an outlet that I never use, I just covered over it. The key to really making this project look good is painting the surface to coverup the look of the plastic. I used a paint with sand added to it to give it a realistic texture. The result is a professional looking job at a fraction of the price of real stone. I couldn’t be happier with the results.

I used two different panel makers for my mixed materials wall decoration project. These panels were a little more affordable but you get what you pay for right. They are lighter but somewhat less durable. They do not hold up well when cutting with a jig per circular saw when needed compared to other brands. The design is great. If you do not need to cut or make any alterations at all I would buy these again.

Goes great on top of tile only if you use adhesive the tape alone don't stick

Not user friendly. Have tries 2 different glues to get the panels to adhere to wall. Nothing worked. Very frustrating.

Used for ceiling on our back patio. Looks AMAZING! Only wish it also came in bigger sheets. Would make install much easier.

You will cuss and cry and swear to never work with these again. But after it’s done…you will be so happy!!!BUY the Gorilla Construction Glue clear-formula. Score the wall a little where edges of tiles meet. Don’t overlap tiles. Paint a grid where tile seams will be before you apply tiles. (You will thank me later). Apply the clue to the wall in zig zag pattern in a large enough area to do 4 tiles. The continuous glue bead from tile to tile really helps the tiles stay in place better. Don’t worry the glue has plenty of time to work with and then you don’t have excess glue running down your project.Once we figured out the above method…we were able to wipe out the last 12 tiles in the time it was taking to do one at a time and getting only 2 done in the same amount of time.