NJSBYL Front/Rear LED Side Marker Lights for 2018-2022 D0dge Challenger R/T Scat Pack SRT Hellcat SRT Hellcat Redeye Widebody Package Smoked Lens White LED Left and Right Markers Lamps

Other than the front driver side-that you need to pop-out the rivets by the tire to get your hand on the lights-these are easy to install. They look very nice compared to the simple marker lights that the factory installs.

I’m so glad that I bought these lights for my Challenger R/T. The smoked lenses definitely change the side profile when the lights are off, but they REALLY change the side profile when the lights are on. They’re obviously brighter than factory, but the styling just sets it off. If you’re considering these, just go ahead and buy them. Plug and play, installed in a few minutes. See attached photos of before and after on my car.

Black the challenger out!!Look great!!

Don't believe the Hype about you have to crawl under the car and turn your wheels get your self a flat head and a cloth are better yet have a set of plastic prying tools and Walla there you have it plug and play

Lights are bright and look very distinct from OEM side markers, and they look great smoked in the day time. I found the easiest way to install is to use a flathead and pop them out on the ends. Trust me, it’s much easier and will save more time than having to pop out the rivets and pull down that plastic piece or even having to get under the car to pop them out.

Rear install was simple and easy however they do not fit as tight as factory. The have very slight front to back play in them.The front installation was a bit more difficult. You must remove your intake air box for the driver side. I have large forearms so even that wasn't enough. I had to get a friend with long skinny arms to remove the factory front side markers. Due to my larger arms i could not reach the retention clips on either side. However I don't fault this company for difficulty removing the factory components.Once the factory front markers where removed the new LED markers where simple enough to install and five very snug. I almost thought they where too large to fit but once i fount the correct angle to press them in, it was simply.Im removing 1 star because of the rear lights being loose fitting. Aside from that, this is a great product.

I put some Saran Wrap around a small flathead and popped out the originals. Do it by the clip side (look at the replacement).Twist the bulb so it unlocks and pops out, pull/wiggle the bulb from the housing, plug the led strip in its place (push till you feel it click, line up black wire to black wire). Pop back in place.Takes all of 30 seconds per light. No funny business.The smoked tint blends in with my pitch black paint, and the LED is so much brighter and nicer.Assuming these hold up (and I see no reason to expect they won’t) I feel these were well worth the money. I’ve seen more expensive ones, don’t waste your money. There’s no reason.If I haven’t posted an update- it means they’re still working problem free.Update: Still working in Jan 2024. If you’re on the fence- do it. I wish I would’ve done this day one.

Don't get conned into spending 2x the money on americanmuscle, they're all the same thing. These are easy to install and look good. Use a plastic trim tool to hit the metal clips inside and release the old side markers. Remove the old markers from the bulbs. Remove the bulbs from the connectors. Plug the ends of the new markers directly into where the bulbs were on the old connectors. Snap the new lights in. Done.The pics with dim half orange and half red lights are the old markers. (obviously)

Found the rear marker lights to be loose fitting compared to stock. Front were way better.

Used lens to replace stock side markersThey look really good and very easy install

Great product! Very easy install, fit perfect and looks amazing! 👍