MEEYO Magnetic RGB LED Light Strip for Motherboard Control and PC Computer case, 30cm 18 LEDs with 4 Pin RGB-Header(+12V,G,R,B) Extension Connector

This RGB strip is very simple and easy to position or move. The brightness level was more than I expected and makes any gaming system look much better. There was plenty of cable so I could have the RGB strip mounted on the top of my case and still be able to plug it into my motherboards bottom RGB controller. I would recommend this for the price and quality.

The media could not be loaded.  These is a great little strip. Colors are spot on, and bright! It connected to the motherboard 4 pin header and worked like a charm. So I tore down the 2060 Super water block and removed the burned up original. I had to shave off some of the clear encapsulation to allow this to fit under the block assembly and the outside case, as it will not fit where the stock LED strip sits. This is much larger, longer and brighter than the stick one. And it works without the Corsair control box.I definitely recommend and would buy it again if need be or want to add addressable RGB to another computer.

This is a great product for the price. I took one star off because the plug was a little hard to get to work on the 4 pin connector on my motherboard. Once you figure out which pin is the 12 volt, it works great. Just line up the arrow on the plug with the 12v. If it is on backward, it won't work at all. The magnets work fine in my case and I don't plan on taking the paper off the adhesive strip it came with. The lights work perfectly with the ASRRGBLED program that I downloaded from the ASRock motherboard website.

Best bang for your buck RGB lighting. This light strip is super easy to install. I love that its magnetic, allowing you to easily reposition the strip to suit your needs. It lit the entire inside of the case perfectly. I bought a second for accent lighting behind some of the components. Love it!

The media could not be loaded.  Works perfectly with my PRIME-X470-PRO motherboard and ASUS Aura sync.It plugged right into the 12v RGB header on the board. The LEDs are nice and bright and light up everything inside the case. I installed it on the right side next to the front panel fans. The magnets weren't strong enough to hold it alone, but the adhesive worked just fine.

The media could not be loaded.  I bought one of these (then a 2nd) for my first PC that I built for myself, so idk how they compare to more expensive LED kits/strips,but for the price, these are great and simple to connect.I later built a PC for my dad, and bought another 1 of these for it.

Makes some pretty lighting.. works pretty well for the price I paid in that regard. Magnets don't do anything; didn't want to paste it to my case yet by removing the adhesive paper. Used electrical tape to hold it in place. You get a little length from the lead wire, not lots. My motherboard is a MSI Gaming Pro Carbon.

the magnet works great, the adhesive holds very well, the lights are bright and programmable, adds a lot for not much money

Did not expect them to be so bright. Easy to install with included extension cable. Take note that this is not Addressable RGB but is the conventional 4-Pin connector.