PGFUN The Latest Upgraded Anti-roll 3D Touch Probe Waterproof Edge Finder Specification: Power: DC5-24V 3 NPN-NO Wiring: Red-VCC (DC5-24V power), Yellow: IO/ Signal Output, Black- GND(DCM) Repeatability Accuracy: 0.01 mm/ 0.0004 in. Feedrate: 50-200 mm/min. Approach Direction: ±X, ±Y, +Z. Over Travel Protection Distance: X- ± 4mm/0.16 in, Y- ±4mm/ 0.16 in, Z- 2mm/ 0.08 in. Lifetime: > 3 million triggers. Trigger Force: XY- 0.3-0.5 N, Y- 2.7N. Application: theoretically it can work with MACH3, Mach4, Dynamotion, LiNUXCNC, UCCNC, Centroid CNC, or any other CNC control software Package Include: 3D touch probe x 1, cable x 1, allen wrench x 1, probe tip x 1, wire connector pack x 1 (to solve the lack of control board wiring ports and extend wire). Software RecommendationProbe Wizard or ProbeIt are recommended for Mach3, and GRBLGRU is recommended for GRBL. FAQs: Q1: Need to turn on the spindle speed? A1: Please do not, or it may cause measurement error. Q2: Why is the concentricity different when the probe is installed? A2: Because the low-accuracy spring collet can't guarantee 100% positive position. After each installation of the probe, even if the concentricity is adjusted to 10 μm, there will still be deviations when the probe is re-installed. So it is best to use a AAA /UP or higher accuracy ER spring collect (run-out tolerance <0.0002") for your chuck. It is recommended to use a high-precision gauge to check the concentricity after installing the chuck. Q3: i need a NC touch probe, what should i do?A3: we added the NPN-NC touch probe, you can buy the right wiring version for the machine now. Q4: Does this touch probe work for the non-conductive material like acrylic? A4: This is a mechanical probe, it identifies and transmits the signal by physical contact, do not worry about the conductivity of the material.
Trustpilot
1 week ago
2 weeks ago