KETOTEK Temperature Humidity Controller Refrigeration Heater Temperature Control Thermostat Humidifier Dehumidifier Controller DC 12V 10A

Ketotek KT100 does not come with any plugs or wiring instructions, tried google too and no luck, looks to be a good product but ive no idea because i cant use it. There are no plugs at all on this product, not even on the power cable.

This device allows you to detect the temperature and humidity and trigger other equipment (heaters, coolers, dehumidifiers, etc) depending on whether the temperature/humidity is above or below a set range. It's simple enough to understand, but be aware that it's not 'plug and play' for all users, you will need to wire it in and understand what you are doing. The input is a simple mains connection, and the outputs are 10A so you could use them to directly power a reptile tank heater perhaps, or a home brew heater. For anything larger, I'd suggest using them to trigger a relay instead. The wires are very short, as you would expect, but there's plenty to spur off from. For the money, this is a decent piece of kit and very useful for someone with a little electronics knowledge.

Checked humidity with a Boveda humidity pack and it was out by 12 percent. I ordered another to see if it was a one off error on my device. The second unit was overeading by 15 percent. Humidity is really important when hatching eggs. I had three other hygrometers that I used and two of them were more accurate than this device.The temperature is pretty accurate although it's hard to check as you can't immers the sensor in ice water. The device once calibrated works well enough, although I found I had to switch it off and on again after making changes on the settings to make changes work correctly. So device is not really accurate hence the 2 star based on having both machines not accurate.

connection cables far too short about 3 inches

I bought this to control the extract fan in my garage. Built a little control panel and it works very well. Just need to calibrate the temp and humidity readings.

Product is working perfectly. First you have to calibrate it to KNOWN temperature and humidity, you can do it in living room or somewhere where you have that info. Everything is written in instructions for use. Great seller too, one was not working and they sent another one free of charge.

As the headline says I thought I'd ordered the item shown in the image that looks like a photo but received the item shown in the other image that looks more like a face on drawing. I didn't realise the wrong item was sent until I wired it up to a heater and dehumidifier and switched it on. The heater came on straight away but three seconds later there was a spark and everything died. The item is dead, the heater no longer works but dehumidifier is still alive. Going back to the original page and then through my ordered items all leads to different items. Not happy.

Great product, just what I needed for my camper