MityvacMVA670 Power Steering Air Bleeding Adapter Kit for Hand Vacuum Pumps, Includes Universal (MVA660), Ford (MVA662) and GM (MVA661) Adapters, 1/4" Barbed Connection, Air-Tight Reservoir Seal

I bought this set to bleed the P/S pump on my 1992 Fox Mustang and it worked flawlessly. I had installed a new rack, pump, and lines and wanted to make sure that the trademark Ford whine was not in the new system. I tried to bleed the air from the system using some of the techniques you find online (turning the wheels back and forth, turning the pump by hand) but it still had the noise. I used this cap with a vacuum hand pump according to the directions and the new system is dead silent. No hissing, no whine, its perfect like a new car. I can't recommend this enough to anyone with an older Ford.

Fits on 2002 Ford Taurus power steering pump just fine and creates a nice seal.But... in the end, I really should have just scrapped the car from the getgo. It ended up needing a steering rack and lines and engine mounts (one mount collapsed and damaged one of the power steering lines). Honestly, 90% of Tauruses on the road don't deserve a tool as fine as this. I regret my purchase because I wasted many hours of my life so that this car could be (barely) road worthy again for just a week before the next problem occurred and I sent it to the scrapyard.

Grate tool and very easy to use. I used in my 02 Mustang power steering reservoir and in a couple minutes I have all the air coming out the system.

Not a bad set. The adapter that you use for GM vehicles is a little difficult to use as you have to hold it in place while using. The other 2 work great. Fast shipping from seller!

Great adapters for bleeding air from power steering pump. These adapters fit many pump reservoirs. Must use in combination with the mini vac or similar hand pump

I had problems with air in the system on a 08 Impala. I used this and the air was efficiently removed. Just set the appropriate cover on your cars pump. Apply vacuum and the vacuum holds the cover on. I applied 25in of vacuum and listened with a scope and I could hear the bubbles. I continued to apply vacuum until it held at 25. The key is to maintain a steady vacuum and give it time. If the vacuum drops it's because its removing air. Worked like a charm.

Excellent product! Fits almost every kind of vhiecle, they seal very good. They are rugged and easy to use.

The seal is hard so i tried heating it up with my car heater vent is was slightly softer but did not seal on my 08 Silverado or my 07 Cadillac asked a mechanic friend to come over and try No joy. I would expect a better design from Mityvac.Updateit still dose not work with any mityvac hand held vacuum pumps we tried 3 but it dose work with a "Motive Products 1702 Power Extractor"https://www.amazon.com/gp/product/B01EVANLRS/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1The motive has a burst of vacuum that holds the adapter down and once it starts it has enough vacuum to stay sealed the motive works awesome we flushed the brake fluid with ease too.

A little bit of the fluid on the O-rings and they worked perfect. Easy clean-up for the next use.

All I can say is it worked perfectly! Thanks to the seller & also for the fast delivery.

Say it works on GM products but I needed two clamps to hold it tight to make a seal. If you have a couple of 8" wood clamps, you should be okay.

Very happy, even seals with 20 PSI back pressure.

It worked as we expected and is a quality tool