Splendide Dryer Vent Kit, Black

I ordered this assuming the kit would fulfil my needs for a dryer vent, which it does. The kit comes with multiple pieces and a very short dryer hose. The hose may be too short for some, but it works well for my use. There are no instructions with the kit. You will need a stud finder and a 4" hole saw. As you can see in my third photo where the black tape is was where the manufacturer said to cut, there was a stud there. Had I used a stud finder I would have avoided that mess, but it was not the end of the world. Simply cut your hole on the inside and drill a pilot hole for the outside, on the outside make sure you put masking tap on your metal so it doesn't tear it up too much. I highly highly recommend using some sort of mastic tape as a seal around where the plastic plate meets the camper and then around the outside of the plastic plate use caulking to have two layers of waterproofing.

I purchased this to replace the original junk one which failed to keep the water out during rain storms or washing of the coach. Since this was installed as a replacement I did not need to cut the hole, and the mounting was without issue. To seal the outside world from getting into the coach I used butyl tape on both the vent and cover and trimmed off the excess. Butyl tape was purchased on Amazon at https://www.amazon.com/dp/B06WLQ3WLS?psc=1&ref=ppx_yo2ov_dt_b_product_details. Be patient when tightening the vent when using butyl tape, and recheck it after a few days since it will naturally spread out some and trimming may need to be done again. Use a blunt (not sharp) plastic type scraper. The vent hose is short and worked perfect for my installation since the washer/dryer is mounted close to the coach wall, and was easily installed with a "S" shape since the dryer output and vent were 4" apart. My space is extremely tight and patience is a must when fitting them. Make SURE the hose is NOT KINKED and there is no obstruction to the airflow. I also installed a drain pan with the new WDV2200XCD and replaced both water valves with quality metal ones from Lowes. Since this is a PITA top of job fix everything once!

Worked great in the camper

Like: I like the design of the vent, it has a closing flap that should keep things out of the dryer vent, but will swing open with airflow. Also, there is a cover over the vent to keep rain from coming in.Dislike: They give you a 2ft dryer hose? I know RVs are smaller, but all of them are different and 2 feet gets you nowhere. My situation needed probably about 4feet of hose. Likely you will have to buy another hose unless you are lucky enough to have your dryer location situated perfectly.

I have installed 2 of these kits in RV's now and each one has been fairly easy. The hardest part of the install is drilling the hole in the side of your RV. Each one I had to go and buy a longer hose. There isn't a lot of room in RV's to start off with and a short hose definitely didn't work for either of my models. The longer hose will allow you to make a connection with the unit out so you can install it fully connected.Overall the reliability of these has been great. 1 RV has had one on for over 3 years now and it still looks like new and I have had zero issues with leaks.

The kit comes with everything but a 4" hole saw

Install was straight forward, get a 4” hole saw, get some courage to cut a hole in your camper and let loose!! I used black silicone caulk to seal everything up and blend in with the cover. Our washer and dryer location is in the center of the front closet so used a 5’ piece of 4” metal duct pipe and a couple elbows to get from the side of the rig to the final resting place. The short 2’ flex pipe that is included will work perfect to connect the dryer to the easy dock wall mount I bought separately. Now I just need the washer and dryer….

Good quality on all the parts. The dryer hose could be a bit longer but it worked well. I found the hard part was to drill a hole in my rv. Stressful. Good thing I checked the wall for a stud