MAYNA Modern LED Pendant Light Fixture, Contemporary LED Chandelier with Irregular Ring Lights, Adjustable Modern Chandeliers for Dining Room Kitchen Entryway Living Room Bedroom, 6000K Daylight

Very easy to install lights are very bright and adds a beautiful modern look to my living room.

This pendant light is absolutely gorgeous and really brought our garage apartment to life. At 470 square feet, the space is modest—but this fixture lights it up beautifully and gives it a distinctive, modern look. We've had potential renters specifically compliment it during walkthroughs.The light leans toward a cooler (bluish) tone—so if you’re looking for something warm and cozy, keep that in mind. It’s made of plastic, not metal, but honestly, it still looks high-end once it’s installed. From a distance, you'd never guess it wasn't metal.Installation wasn't the easiest—our contractors had to put in a little extra effort—but they got it done without issue.Overall, this fixture adds a bold, masculine touch and a lot of personality to the room. A great buy if you want a striking piece without breaking the bank.

A beautiful dining room upgrade. Dimmable light, perfect size for space

Love love this lamp. It’s just what I needed for my living room. I get so many compliments from my guests

Very nice light, smaller than expected, but I like it anyway. It's in a small room,so it's fine.

I love, love, love my light. It's very bright & it makes my room look so elegant. I will definitely recommend

Used in foyer. Will probably add the dimmer switch since its very bright. Read other reviews regarding shortening/pulling the wires through, as they cannot be reversed.

The light is very nice for the price and it’s bright.Installation is easy, but some very important tips so you don’t have to mess up like I did and have to exchange it.NOTE: These are not mentioned in the instructions.1. Measure your length then mark with tape the wires on the side closest to you. We used painters tape. If you mess this up, you’ll pull the wires too far and they cannot be adjusted. You will damage the entire unit.2. Once you have the marks, pull the wires through but leave an inch or two from the flat surface until you finalized your cuts.3. Keep the wires even and flat with your measurements. The light should hang the equal lengths with the two braided wires and the lighting cord.4. Get a good set of wire cutters, make sure you don’t pull the wire as you cut the excess. Same reason as above, you will pull too far and mess up your length.4. The small screws require a mini screw driver.5. Install the bracket first (make sure the power is off) then mount the ground wire to the bracket. The helps with leverage and secures it to the ceiling.6. Match your black and white wires and put the rest of the housing in the ceiling. Tighten the screws to the bracket.We did about 18” down with high ceilings in a room about 10 X 11’. See picture.Hope this helps!