Greartisan DC 24V 500RPM Gear Motor High Torque Electric Micro Speed Reduction Geared Motor Eccentric Output Shaft 37mm Diameter Gearbox

A+++

I built a filament respooler that called for a 100RPM motor. (not pastamatic, the original one) I bought the recommended motor but it was loud and to be honest, a bit slow for my tastes. I found this motor which is faster and quite a bit quieter. (by no means quieter, just a lot quieter than the other motor I used) I am guessing the noise is from the gear box. I can use full speed on my motor controller but it is a bit too fast. I can slow it way down and it still works. At a certain point, slow is just off. (pretty close to the off position) I recommend this over the motor listed on printables because it is quieter, faster and much less expensive.

Excelente calidad, los recomiendo.

This low speed motor (60rpm) has more gearbox noise than I was expecting, which is still tolerable though a bit annoying. Because the motor is geared down to such a low speed, the torque is enormous making it almost un-stoppable. But the gearbox losses make the no-load current pretty high. I have had it running under light load for about 4 hours now - It does get slightly warm, the current and speed have not varied, so it seems like good value.

The size of the motor was perfect to create a rotation device for a roaster. Low noise, just the right amount of power as I wanted to spin slow. It worked as intended.

it met my expectations for my experimentation

Works just fine. I needed a DC motor for my DIY project and I see no issue's with this motor. up to 15 kg torque.

Works great, but absurdly loud gearbox even with upgraded grease. Taking a look and it's basically just down to slop in the gears.