Partsam LED Strip Light Bar 2X 6 LED Black Third Brake Light Motorcycle Turn Signal Backup License Plate Universal Amber Lights Strip

these lights are extremely bright and installed in 10 minutes with soldering and heat shrink time included. these use the red 3m tape backing just apply to a clean surface and they will stay there till you decide to remove them. the wires are very thin so id heat shrink over your install for added strength. excellent product at a cant lose price. these went on a 94 fxsts that i added hard bags to. i kept breaking stock lens covers from the vibration of the turn signals mounted to the softail relocation bracket. no issue with these, they are only maybe 2 oz each with the wire. i placed them just below the saddle bag lid and ran the wire aroumd to the mount and under the fender picking up the single wire for the hot lead then put a round fitting on the ground and bolted it to the fender strut. works like a charm.

The media could not be loaded. I bought a set of saddlebags from Amazon and needed a turn signal relocation. I purchased the 4" amber lights for turn signals. I spliced the wiring to the existing stock wiring under the fender and viola! Works great. Very visible during the daytime as well.

I picked these up to replace the LED strips that were being used as rear turn signals on my 2004 Yamaha R6. The previous owner added a Fender Eliminator Kit to the bike, and when he did so, used LED strips like these for the turn signals. The problem is that he used red, so when the brake is applied, the red from the brake light drowns the red from the turn signals and you can't see that it's even on...These, work perfectly! They're amber in color, so you can see them even when the brake light is on, and they're bright enough at any time of the day or the night to be easily visible. So far, they haven't even come close to starting to unstick from my fairings, and I don't see that happening anytime soon, honestly.For use as turn signals on the back of a motorcycle, I'd say these are perfect!

Installed these on the passenger foot rests as turn signals on my Honda f4i so I could remove the bulky old turn signals and stream line the back of the bike more. Install was easy. The lights work nicely and are about the same brightness as the old turn signals. I had to wire in a resistor with each LED to stop the hyperflash. Also siliconed the ends to be safe. Only reason for the for four stars is because the lights themselves are completely clear so you can see the insides and it looks a bit cheap then. My fix to that is going to be to cover them with vinyl wrap and cut out the light parts. Second the wires are 20 gauge and hard to wire in because they are so small. But overall a good buy and perfect fit for what i needed them for.

Works flawlessly, bright, and made of good components!

Install doesn’t get easier than this people. I installed on my Roadstar bobber build. I wired directly to my existing wires and had NO hyper flash. They flashed just as they didn’t with the stock signals. I do wish they were a tad brighter, but I can’t complain for the price. I can’t speak much about how well they stick long term just yet. Just cleaned the area very well with some prep all and slapped them on. Initial review is 5 stars, will update if anything changes.

Used these as blinkers on a '14 ZX10R. Really bright and stuck well. Work very well and really like them. Would buy again.

3 star overall. I purchased 4 of theses LED strips to use as turn signals on my Triumph motorcycle. I’ve used many products with 3m tape and for whatever reason the adhesive on this product DOES NOT adhere well at all. They are bright and work but I was counting on them to stick to my bike and they don’t, at all. Cleaned my surfaces very well, applied at room temp and pressed firmly for about two minutes. The second I let go they just fell off?