PSEQT 10" 15 LED Trailer Identification Light Led Running Reverse Backup Tail Light Bar Strip White Truck Rear Side Marker Lights Waterproof

UPDATE: I redid all of the grounds and I know they are good. All bare metal connections and the trailer lights work perfectly. My issue is still with these new LED lights.I have left and right directional. I have break lights, I even have break lights when I use the directional.What I do not have is the lights working with my head lights. When I put on the head lights I do not get these to light up. When I put on a directional I still get all of the side markers (both sides of the trailer) flashing along with these new lights and ny trailer directionals.I went as far as to swap out the wires and connect the black where I had the red and the red to the black and I even connected them all together! The results were not good though one combination did get me the driving light on but nothing else. I am settling for the original configuration and I will sacrifice no driving light and have flashing side markers . No idea what else I can try. I mean it is a simple flat standard trailer connection (white, brown, yellow, green) and all other lights I have ever bought (this trailer, boat trailers) worked as designed.I connected these to my existing wiring on my utility trailer. I put the black wire to the brown (tail light, side market, license plate light), the Red wire the Yellow and the Green (LH stop and turn signal and RH stop and turn signal). Whit was connected to ground. My issue is when I turn on a directional all of the side markers also flash. DOesn't matter if I do Left turn or Right. If I disconnect the brown wire I lose the directional function of these lights. I also tested the ground and that is working well.***************************************************Anyone know how to wire these so the side markers do not flash with the directional lights? I am confusing people (I think) if all four side markers flash when I am taking a left turn (or a right turn).

Have a kawasaki mule and hated the factory tail light and reflector. Took about 10 minutes to replace with these. Gives it a much more modern look, plus they work great and have a good brightness to them.

Nice looking lights. Installed these on my Golf Cart. Work just fine.

I used it for a third brake light on my golf cart

works

I had to snip and reverse the wires on this to get them to work properly but they work great nonetheless. I wish they were a little bit brighter, but they’re not bad for the money.

Works perfect using the brighter setting. Easy install. Would do it again and recommend to a friend v

The media could not be loaded.  About 10" in length.3 wires:Red- 100% for brakes, turnsBrown- 50% for run lightsWhite- is the negativeWhen purchasing cheaper LEDs like this, try not to pull on the wires to hard or they may pull out of the light. You can't go wrong for the price.This lights have two holes on each ends to screw through or bolt like I did to my headache rack.

Calidad es sobresaliente en comparación al precio

Buen articulo en precio y calidad

Cumplen con lo esperado

SE INSTALARON EN EL REMOLQUE Y EN LA PRIMERA INMENSIÓN Y HUBO FILTRACIÓN DE AGUA DENTRO DE LAS UNIDADES, LOS FOQUITOS NO FUNCIONAN EN SU TOTALIDAD.SI VUELVO A ADQUIRIR EL PRODUCTO LO AISLARÉ CON SILICON PARA EVITAR LA FILTACIÓN DE AGUA.ME RECERVO LA RECOMENDACIÓN DEL PRODUCTO.

Attached to my bike carrier for additional tail lights and direction signal. Perfect, just add trailer wiring harness.