AntraderZinc Alloy Rectangular Pull Handle Locker Bail Cabinet Ring Pull Elliptical Grip, 3.74" x 2.04", 4-Pack

Exactly as represented

I bought a used desk with no hardware on it. I couldn't find hardware that would fit the original holes, but I liked these, so I bought them, knowing I'd have to drill new holes.Pros:- Looks good.- Good medium weight.- Solid feel.- Satin finish.- Consistent hole locations.- Screws included.Cons:- No drill guide.- Priced a bit high, even now.- Screws were too long, & needed to be ground down. (May or may not apply to your furniture.)- I had to add washers, because my drill holes got too big for the screw heads. They're not leaving a lot of wiggle room on that screw head.Overall, I'm happy with these. They look great, & have a solid feel. (The handles themselves are like a hollow straw, cut like a cross section, but they're still solid feeling.)The worst thing, which could be easily remedied by the seller, would be a simple drill guide, that showed the hole placement, & drill size, rather than leaving each new buyer to figure it out for themselves.I made myself a paper guide, which I had to make more than once, because I bought 2 sets, so 8 altogether, & no paper can be trusted to hold up under that many drill holes. A cardstock guide, with punched holes would have been a lot easier than my pencil marks on a piece of paper.Given the fairly high price of these, I'd say the 10 cents it would cost them to do that, would be something they should consider, & just clearly State the Drill Size needed, since the handles have an extended (& tapered) post to accept the screws. It's hard to gage what size drill is needed by eye, on a tapered post.Also, the screws are quite a bit longer than need be. My drawer fronts were plenty thick, & I had to grind down about a quarter inch on all 16 screws, so that wasn't fun. The posts stick almost all the way through, so the screws only needed to be about a half inch long to meet it, but were so long, they bottomed out, well before the depth of the drawer front was engaged.

I didn't realize until it arrived that screws were not included... my fault for not reading. Any idea what size screw it uses? I went thru my can of spare screws and can't find any that fit. Also tried the screws for the handle I was replacing... no luck.

I only received 11 of the 12 handles that I ordered. I was not able to get my order until September as I couldn't cross the border from Canada to the US where I had them shipped and the return date had passed. That aside, they are not as thick as I would have liked but they do the job. The handle goes flat against the back so harder to grab to open a drawer. The are not heavy and not solid. The screws were too long so I had to purchase more to make sure the handles fit tight against the drawer. I like the look though.