DIGITEN 5x20mm GDC Fuse Holder Inline screw type with 16 AWG wire (Pack of 10)

I've had excellent results with these which I have used in building various electronics projects. The 16 AWG gauge wire is sufficient to carry much more than a 5 amp load. The screw connectors are of good quality plastic and have a spring inside to hold the fuse securely. The wires are also pre-tinned. Buying a new package because I only have one left. Highly recommended!

I have very little experience with electrical circuits. Fortunately this was exactly what I needed to replace a damaged fuse and holder for my Pullet-Shut automatic chicken door.

I either misread the description on this or they sent the wrong item, these holders uses the itty bitty fuses, they done me no good, if they were what I needed then they are fantastic

It’s great

They are exactly what I was looking for. They seem good and solid. The price was great too!

The fuse contacts were bent which does not allow all of the surface area to mate with the fuse. I bent the fuse holder contacts to achieve 'almost' parallel contact with the fuse. With the straightened contacts these fuse holders could be used with low amperage fuses. You decide. The spring tension on the fuse is very good. (I'm using these fuse holders with 50 ma fuses, so no worries here.) I would inspect each fuse holder before use.

Used to fuse a new LevelMatePRO in RV. No issues

I purchased these after I had to rig a fuse bypass on the motherboard on my fridge. The fuse on the fridge was hard wired to the board, the bypass now allows me to replace the fuse if it should ever blow again.