EWAY for Toyota Tundra 2007-2014 4.3" Rear View Mirror Monitor with Tailgate Handle Backup Camera Kit Parking Waterproof CCD Reverse Reversing Night Vision Car Safety Backing Auto Cameras

I purchased this package as an add on to my 2008 Toyota Tundra and it fit perfectly. The camera is in the handle of the tailgate and gives a great view for backing up and especially for connecting a trailer to tow. I also like that the screen is in the mirror that turns on automatically when the reverse lights turn on. I had a minor issue with my screen and the company had great customer service to help me. I would highly recommend their product!

Camera blends well in stock handle location, and back up camera screen can’t be seen unless it is turned on. Much better than having an extra screen on your dashboard. Mirror has a tint layer or something on it that gives an unideal glare sometimes

Bought this as a Christmas gift for my husband and it only lasted 4 months. Worthless piece of junk and the extra warranty I purchased on it is equally worthless as no one will respond to request for support. Buy something else!

Fit perfect on my toyota tundra. Instructions are a bit confusing, but once you get the connector switch in the configuration you want (mine is reverse only on), then it's great.

Super easy install, only time consuming part is removing and replacing all the trim pieces to run the wiring. Highly recommend. The picture quality is great and the angle of the camera is perfect.

2010 Tundra. The directions lack a little for installation. I had to look up two different Yoututbe videos. Tailgate handle installation is easy. I sprayed WD40 on all parts, to include latches on tailgate. No binding, works smoothly and does not feel like it will break. I used a coathanger to thread the wire through the tailgate to the bottom. The length of wire for each portion was plenty. I tied in the red (power) wire to the red wire of the backup light. The little attachment clips included worked fine for this. I attached to black (ground) wire to the frame. I ran the long cable next to the cable wires already on the truck. The kit provides some flexi's but not enough in my opinion for the entire length, so I had to use some of my own. Getting the cable into the cab was not difficult if you find the correct video. I cut a slit in a rubber "gasket" on the bottom floorboard and ran the wire under the carpet to the door sill. I removed the rubber door seal and ran the wire behind that. Installation of the mirror was easy. Running the wire from the mirror to the door was simple, used the hanger again to get under the headliner. You can connect the two red wires together (from each length of cable), no need to find another hot/power wire.The two white wires on the cable from the camera are for the lines in the camera view. You just have to remove a small plug if you want the lines to show. Mirror does enlarge the view a little, so that takes getting used to. It also has a blue shade to it, so it helps dim the view. Overall I am very pleased with the look and result. Not five stars due to the installation directions.

Handle is flimsy , not the same as factory, weak on the right side , however camera is good

Camera is not the same quality of replacement parts is very poor