iJDMTOY 12V GS-100A LED Brake Stop Light Strobe Flash Module Controller Box Compatible With Car Truck Third or High Mount Brake Light Retrofit

I had one on my previous motorcycle. And now on the new one too. It flashes like 6 times super fast, 4 times slower (like a blinker) and then comes on solid. It increases brake light visibility by grabbing other drivers attention. I highly recommend it for motorcycles especially. I am also considering putting one on the third brake light in my truck.NOTE: This will only work with LED lighting.

• Easy to install• Small• Comes with wiring connectorsI’ll keep the review updated in three month increments.

Installed the flasher in my 2016 Focus ST and initially used the supplied crimp connectors. Once I put the car back together, I noticed it wasn't working. The crimp connectors that came with, I had noticed upon removal that the metal crimp insert was half missing, so I was crimping with just the plastic. Got frustrated thinking it was the unit at first, but once I soldered it in place, it worked wonderfully. Sadly, I could not install this inside the vehicle without doing some major tear down of panels, so I installed it in the spoiler as there is a ton of room. Because it was now subject to weather, I decided to pop the box open and completely encase it with RTV to make it weather proof. Will buy again for my other vehicles but will solder the first time around.

Got pulled over by Highway Patrol, she thinks it was broken, Bought this gadget for other drivers around me for attention since they can't stop looking at their phones. With a pulsating LED light , it highlights my XB's rear and the highway patrols attention mehehe. Drivers can see my brake light but law enforcers can not see those drivers looking down on their phones

The media could not be loaded.  I installed this module in line with the third brake light on my 2007 Infiniti G35 coupe. I looked up the wires I needed to splice, and it was a fairly painless process as I have done wire splicing before and was comfortable. I wanted to circumvent cutting wires altogether by just using blue PosiTap connectors, but unfortunately it does not work this way and the wires do need to be spliced. Took me less than 45 minutes total, and that was going slow and taking my time. Definitely worth the effort.

NOW...After exactly ONE WEEK of use...the GS-100A LED stopped working...it burned out.I tested the lights, all is working when you removed this CHEAP MADE device.I is a no go, I wonder why AMAZON continue allowing these BAD products in their market, once again, I strongly believe AMAZON will become another eBay...Works as expected, it was an easy install after a requested instructions.Could get a 5 stars if seller added just a line of instructions (THIS WAS WHEN I PURCHASED)

Easy to instal

I liked how easy it was to install this mod. Ideally soldering it would be best but I used some crimps. I have a Subaru and it was pretty easy to get to the wires of my 3rd brake light. The blink sequence is blink-blink-blink, blink, blink, blink, then stays on. I definitely like the look it gives and the extra awareness when I brake. I have seen a lot more blinking tail-lights, but none like mine so far. I think this sequence looks best too.