Partsam 2X Amber + 2X Red Side Fender Marker Assembly Replacement for Ford F350 F450 F550 1999-2010 Super Duty Full Kit Dually Bed Led Fender Side Marker Lights Aftermarket Front Rear w/ T10 Plug

They got here fast and the ones that I received were easy to install and look great. They ate bright as well. I did end up putting electrical tape around the connections to keep them held in and protect them a bit. The problem that I have, and this is a big one... I looked in the box several times and could only find the red ones. The amber ones didn't show up. I sent an email to see if/when they will send the amber lights. When I get those I will update the review.Edit: I have talked with Partsam through email and they have shipped me two amber lights. They were very quick and responsive about it. The red lights are much brighter than the OEM lights and in my opinion look better though they do stick out a bit more. That's just because of the design compared to the OEM parts.

Great quality, great upgrade from factory

They are bright and very easy to install. One tip I have is to get some 3M Adhesion Primer 94 and of course clean the area first with alcohol. This will make it so it is on rock solid. One thing I don't like as much compared to the stock lights, is they do stick out quite a bit more. The stock lights were lower profile which I like so there is less chance of them getting busted, and I feel it just looks better. I don't think that is enough reason to knock of a star though, especially for the price.

Installed these for my neighbor's 2002 F350 dually diesel. If you are careful when removing the old side markers you can simply plug these in to the existing socket that the old non LED bulb would have fit in. We used a little dielectric grease also and I put some large shrink tube over the socket and wiring to the led markers to provide a little more weather protection and solid "slip free" connection. Only took about fifteen minutes to install and I would advise checking the function of each light as you install it as inverting the connection causes the light to not operate.

Easy to install used on my 2002 f350 dually fits great and makes it look so much better

Purchased to replace cracked and non-working side lights for bed of 2008 F450.Cannot plug into factory wiring without cutting off connector and "rigging" from there. I tried, unsuccessfully. No way to make it water-tight or secure.Don't fit factory cutouts.Can't tell if adhesive will stick or not or for how long as I threw them away in disgust.Cannot return since I "modified" one of them in an attempt to make it work. Should have known they were junk by the price.UPDATE: After more thorough review I discovered these plug into where the BULB plugs in, not the fixture itself. Very simple, did not require removing the fender liner (a PITA), and so far so good.I was hasty in posting my original review.

Pretty sweet!. You have to splice in these harnesses, they are not direct replacements and they stick on with 3m tape. But they look great.The two red lights stopped working after about 6 months. Guess I'll buy another set.

As advertised, good value, good quality

Very easy to install and look good