Integy RC Model T8098BLUE Evolution Alloy HD Gearbox for 1/10 Slash 2WD, Electric Stampede 2WD Rustler 2WD

Loose tolerances compared to the original plastic part (picture 1). Gears can wobble significantly enough to slip.Picture 2. Screw hole not sufficiently spaced to allow nut advancement to fit against opposing surface. Could be resolved one of two ways: thread the hole so no nut is needed, or remove material from outside of gearbox so that the nut fits. This could also be a QA issue and not an engineering fault, but the threadless design seems to argue against the engineers.Would not recommend to my friends.

Would not recommend buying if you have a slash 2wd the case is to big and everything on the inside moves freely when it shouldn’t yes it looks cool and all but after putting on my truck have had nothing but problems and have had to replace all the gears and diff many times and haven’t had it very long so don’t waist your money like I did

A great upgrade for a lot more durability and especially for those who want high speed runs can install a wide range of spur and pinion

Looks pretty on my car

looks great woks sweet

Put this one on the Custom Build. Looks sweet. Satisfied customer.

Installed into a Stampede. This gearbox worked out well for me. Swapped all of the stock internals from the stock gearbox to this gearbox without an issue. Bearings fit fine for me. Heard about some people having to use tape around the outer ring of bearings to tighten up the fit. Could be worn bearings in my opinion. It is pretty much a huge heat sink for the motor. No need for a fan even under 3s LiPo loads. The aluminum will sound a little noisier from the gears whining. The plastic stock gearbox kind of dampens the sound. This would be a good time to grease the gears when you take the stock box apart. Either way, noise isn't an issue for me. It's no louder than a brushless motor screaming at high RPM's. If you are using a STRC Rear Shock Tower then mounting the tower to the gearbox will be a tight fit but it goes together fine.

Excellent replacement part, perfect for my rc car

Super bien avais eu de mauvais commentair ,ces bien monte et bien instaler

Was soll ich sagen schaut super aus guhte kwalität und past genau und bei modellbau bochum kaufe ich auch gerne immer schnelle liferungen einfach super