GToggle Switch Panel, DC 12V 20A Blue Round Lighted ON Off SPST LED Switch Panel Control for Ships, Yachts, RVs, Buses, Trailer, Camper, Boat etc

I got the three-switch version. The plate is nice. Not cheap plastic. I had to drill out the holes a bit, and there were strands of aluminum coming off the bit. The wiring is simple, but nowhere explained. Use a 16-22 gauge female spade connector to connect the positive lead of your device to the MIDDLE connector on the switch. (The seller says you don’t use it, which is just wrong.) Use some kind of 16-22 gauge connector (e.g., a butt connector) to connect the red wire that will attach to the positive terminal of your battery to the red pig tail wire coming off the switch. The wiring on the switch appears to be 16 gauge (16 AWG), even though the switch says it’s rated for 20 amps, so I wouldn’t load the switch (or switches if you have the three switch version) with more than 13 amps total. Next, strip about a half inch off the end of the black wire coming from your device as well as the black wire that will connect to the negative terminal of your battery. Then twist the ends of these wires together along with the black wire coming off the switch and secure them with a wire nut. Wrap with electrical tape to make sure the wire nut doesn’t come off. Now connect wires to the battery. Don’t forget to splice in inline fuses of appropriate amperage between the switch and your devices if they don’t already have them. That is easy to do with butt connectors. For extra security, secure all connections with shrink tubing and a heat gun. Slide the tubing down the wire before crimping, of course. That’s it.

added this to my ford e350 to control my trail lights and it works great. i cut a hole in the panel and simply screwed it in place with the supplied hardware. the build quality was impressive and works well and seems robust. i dont believe it came with instructions but its a pretty strait forward install

I was trying to find a toggle switch that I could place on the side of a council on a boat and be able to secure properly. This product worked awesome

Worked perfectly for my small project. The leads were connected on the terminals that illuminate the small blue led on the switch, so I had to figure out how to just get a simple off/on config as I don’t need the blue light. Screws are good quality, as is the switch.

This switch was installed to turn off the under hood light on my ‘63 Galaxie while at car shows. Simple to install and low profile. I chose not to illuminate the LED on the switch in my application.

As there are no instructions on how to hook up this switch, I relied on several of the previously posted reviews to figure it out. Here is a schematic that hopefully makes it easier.

It Works

Made well, light has the perfect brightness.