CubiCubi Computer Desk 47 inch with Storage Shelves, Home Office Desk, Study Writing Work Table, Modern Simple Style, Deep Brown

One of the biggest things I required was to ensure there was space for a mid tower and not flat on the floor, as the desk sits in a carpeted room.With almost 11K reviews and 95% approval rating, I took a chance on this desk. I don’t regret it.This is a particle board with a thin, steel frame, hence, it is not the strongest. As long as you expect for its placement to remain static, it is sturdy. Had all the boards sat on the steel frame like the main table top does, I have no doubt this would be 100% rigid with zero play. The fact that the shelves actually stabilize the structure on the side, explains the very minimal play/wiggle it does have.Make no mistake, if you taut everything finger tight, it will be solid, I DO NOT recommend using power tools. A manual, multi-bit screwdriver set is highly recommended, and it is what I used. As you can see in the pics, even finger tightening started sinking the frame at the screw holes.The shelves are indeed interchangeable. I’ve seen a couple reviews that say they are not, this is not correct. Just make sure everything is facing the side you desire and that the screw holes all line up on the side you wish them to be. I actually had to undo the tower shelf because I lined it up wrong the first time. I recommend you verify the alignment before putting everything together.I cannot verify how much weight it will hold up but my bare mid tower, a NZXT H5 Flow, is 15.5 lbs. and 36.4 lbs. with all the components. Unlike the shelves, the main table top sits on the frame rather than supporting it. Despite that, I am not risking ruining the desk to verify how much weight it will support. The monitor in the pics is hefty, 32 in., weighing approx. 35 - 40 lbs.Very quickly, I will say that lining things up can be a little difficult, but the very minor alignment issues are negligible and do not affect use in any negative way. (see pic).The width of the tower shelf is only 8 in. (approx. 204mm). My tower case is 8.94 in. (approx. 227mm) so it technically doesn’t fit. The feet are approx. .5 in. (half an inch or approx. 12.7mm) inward from the edge of the case so it does sit on the shelf (see pic). The height of the tower is also very compromised. At 18.27 in. (approx. 427mm), it does not allow for full towers and just enough for most mid towers, giving you approx. 19 in (about 483mm). Luckily though airflow is NOT compromised. That said, I would recommend a case that is longer, shorter, with 9 in width at the absolute max if you want to use this desk. This is of course assuming the feet of the selected case aren't at the edges of it, for best fit.Overall, I am very happy with this desk. It met all my needs, is sturdy, and enough extra space for a couple more things in the future. It is obvious from the pics that it is a great desk for limited space.

For the price, this is a very good desk. Is it as solid as something more expensive? No, of course not, but it's quite adequate to handle a computer, monitor, and all the assorted accessories that'd go along with that setup. I'm not sure I'd place something like a multifunction laser printer/copier/scanner on it, but, once you place your monitor, you really won't have room for one anyway.I ended up buying two of these for our kids' computers, so I'll run through the assembly process. The desks were packed well, and, although there was some minor damage to the corners of the boxes, everything inside was fine. The assembly instructions consist of only pictures and diagrams, but I didn't have any problems following them. In terms of difficulty, most of the assembly can be done by one person, although there are a few places where having a second person can be helpful. The hardware is well-organized, and, for most items, they give you an extra screw, bolt, or nut.The most important advice I can give you is to take your time and pay close attention to the orientation of the metal frame pieces as you put them together. You can easily assemble something the wrong way and not discover it until several steps later, meanibg you'll need to take things apart to correct your mistake. An allen wrench and a small wrench are included, and I'd recommend using those instead of power tools, since you could damage the parts if you aren't careful. Also, don't tighten screws down until you've got them all in for that step of the process. That'll allow you to be sure everything is put together properly and everything lines up. Just take it slow, and you'll be fine. They recommend that you watch their assembly video on Amazon, but I chose not to, so I don't know how helpful it'd be.All in all, this is a good little desk. I haven't had them long enough to comment on how they'll hold up over time, but I don't see anything now that's concerning.

I'm pretty skilled at putting together furniture of the Allen-wrench variety, but I made things a lot harder on myself with this one by not paying enough attention to the directions. The pictograms are VERY informative and clear if you actually follow them. The most important thing is ensuring that the pieces are facing the correct direction when you fasten them together. The second most important thing is ensuring you use the correct screws for the purpose. The pointy screws are for joining the wood shelves to the frame, the blunt screws are joining the frame together. Don't mix these up. Once I figured out where I went wrong, the desk came together pretty quickly, and I am very pleased with the result. One thing I would note is that this isn't necessarily a good option if you are using a monitor on a stand, as it's not quite deep enough to be comfortable when using a laptop and that stand (for me). YMMV.

I had purchased a black drafting/computer desk and was looking for a small desk I could add to the right side of it that could help expand my desk area. This desk matched it perfectly! I circled the desk in red in the photo for reference. The “computer shelf” was not wide enough for my big computer. So I went to Home Depot, purchased a wider shelf and had them cut it to size. It hangs out a little bit, but that’s ok! It’s doing the job perfectly!

Easy to follow assembly instructions and a simple one person job! Exactly as pictured, durable, and functional. The added shelves (which are height adjustable) are a great touch. The bottom shelf is perfect for a computer tower. Spacious but will still work well in smaller spaces.

Desk is amazing, just wish there was more storage space. It's very sturdy however it's so hard getting crumbs out of the grain. Otherwise, could use a little more leg room. Thats it though. Desk is great.

Fits everything I need on it, just wish it could be a little sturdier out of the box. Had to doctor it up a little bit.

It's large but compact. The dimensions work perfectly for my intended uses and come at a great price.

Emballage très soigné, Documentation parfaitement adaptée et très claireBureau d’excellente qualité et très esthétiqueJe recommande ce produit et ce vendeur.

En general, la mesa cumple con su función. Se recibe un solo bulto con todo lo necesario para montarla, tanto herramientas como manual de instrucciones. El montaje es simple, aunque aconsejaría hacerlo entre dos personas.La mesa blanca tiene un acabado con la textura de la madera y combina bastante bien con cualquier lugar. La única pega que le pongo es la estabilidad; si la vas a usar para programar con un monitor con el de la imagen (que es mi caso) tienes que tener en cuenta que puedes notar una vibración cada vez que escribes. No es molesto si no te obsesionas con ello, pero es para tenerlo en cuenta. Esto supuestamente lo podrías arreglar si añades un refuerzo a la parte trasera de las patas, o bien la anclas a alguna pared.Por lo demás, la mesa cumple tanto en forma como función.

Belle finition du produit! Attention au sens des pièces en le montant sinon il faut tout re démonter

Génial! Rapport qualité/prix au top. Je l'ai utilisé comme plan de travail dans une petite cuisine qui en manquait ainsi que de rangement. Je conseille vraiment cet achat.

La photo est mensongère (encore un produit chinois) et le bureau n'est absolument pas en mesure de réceptionner un MacPro comme cela est montré sur la photo.Dommage, je l'avais acheté uniquement pour cette raison.Sinon le meuble en lui-même est de qualité, solide, et est bien conçu.