Zonon 5 Pcs Clear Polycarbonate Sheets 12 x 12 x 0.02 Inch Thin Plastic Sheet Resistant Plastic Panel Acrylic Board with Protective Paper for DIY Crafts Document Picture Frames Easy to Cut Bend Mold

This was the perfect material to use as a top cover for my 2 gallon nano tank. It looked extremely transparent, almost like nothing was there after I was done cutting it out with scissors. If you wipe it with anything however, it'll scratch very easily because it is plastic after all.

These are exactly as described and was exactly what I needed. I was a little hesitant to try them, seeing as how one reviewer said they weren't clear. I had purchased polycarbonate film from another retailer (not Amazon) and those were described as clear, but when it arrived it was actually a velvet clear finish (which is a little cloudy) and it had no protective film on it, so I could see some fine scratches from storage and shipping. That's not what I wanted. I needed absolute crystal clear. So I decided to try these.Bam!! exactly what I was looking for. Clear as glass after you pull off the protective film on each side and no scratches, thanks to the protective film. Perfect!Be aware....They are .020 (20 Thousandths) of an inch thick. Don't expect anything different. If you're not aware of how thick that is...get a set of calipers and look before you buy.

I needed some Plexiglas equivalent to make a secondary windshield that would redirect the wind up when I raise my motorcycle original windshield. It needed to be thin as otherwise the screws that would hold it in place would no longer be aligned with the parts they belong to, and it needed to be resistant to withstand the wind pressure.The first part I had made was with a different material, too brittle.After a year of good service, it finally shattered on a 485 miles road trip.Enter this material. Easy to cut, very transparent, flexible and thin enough.Perfect.For MY job.

Looked good coming out of the packaging and is crystal clear. It cut well enough on my sheet cutter, but it just caused me to brake my cheap new hole punch. So I ordered a new hole punch and round two starts tomorrow.

I got exactly what I needed and the description was on point

I added this to the bottom of my Table Saw Miter Gage to eliminate the metal to metal contact. It was easy to trace the outline with a fine point Sharpie and cut with a utility razor and scissors. It attached firmly with very thin woodworking double-sticky tape. This stuff measured .5 mm thick and does have a removeable protective cover. Very solidly feeling polycarbonate.

The media could not be loaded. I ordered these to make a Pepper’s Ghost effect in a hatbox, for my son’s “Hatbox Ghost” costume for a Halloween party at Disney World. These went into a hatbox, and using some foam and an old Android tablet, I was able to create the hatbox ghost’s head (or my son’s head) illusion/effect.

I wanted to use these on my glass top tables to avoid scratches during parties. They are good quality, but they aren’t crystal clear. They have a slight film over them.