BRINGSMART DC 12V 80rpm DC Worm Gear Motor 15kg.cm Self-Locking Reversed Engine Mini Turbine Geared Motor for DIY Robot Rotating Table Door Lock Curtain Machine (12V 80rpm)

Plenty of torque in a small package. I'm using one for a Halloween prop. Great choice because of all the different RPMs available. Would buy again.

The media could not be loaded. I’ve seen others who have been interested in motorizing their Coolaroo Roller Shades. Well, I wanted that to so I figured out a ‘fairly’ easy way to do it. I’ve included a picture of the configuration and a video of the movement. The parts are: 12v 80rpm Reversing Motor B07F8S57JT , 8mm Flange Coupling B0822425TT , Motor Mounting Bracket B073NZ81M9 , 12V Momentary Rocker Switch (DPDT) Reverse Polarity B0885W19KL , and a 12v ~10amp Power Supply. It will take some playing around to get it all put together, but getting the right pieces was the hardest part. I didn’t play around with trying to get a controller that would have stopping points. Just one more thing to break. So, with this it’s manual stopping points controlled by removing your finger from the switch.I mounted my configuration to a backing board. This allowed me to get it all setup before mounting it. The motor end has to be elevated a little bit to get the roller perpendicular to the backing board. The non-motor end is just the clip-in end that comes with the Coolaroo blind.Take the black plastic end off of the blind that will be attached to the motor end. Attach the flange coupling to that end. I had to make some modifications to the interior of the tube to make room for the small nuts and screw ends I used to attach the coupling. Figure out where the motor needs to be mounted. Once the motor is mounted you can slide on the coupling end on to the motor, lock it in place and snap the other end into the clip-in Coolaroo end.Search for “reverse polarity wiring diagram” in order to see how to wire the switch. For my testing and video I used a weak (1.5 amp) power supply. Using a 5-10amp supply should provide a little more umph. I experimented with a 6’ blind. I don’t believe the motor I used would handle anything bigger. It just wouldn’t have enough torque.Mine will be hung on the outside of the window. I’ll need to get wires into the house and figure out where I want the switch. I’m thinking of just embedding it in the molding on the inside of the window.__________Up for 2 years and working well.

Works great, only a slight hum. More noisy than a tape recorder motor, less noisy than just about any gear motor. Lots of torque.

Strong motor for size.

Well built unit

The media could not be loaded. This thing has tons of torque probably gor to get a 45 rpm one this ome is 16 but has no problem. Using it on a homemade milling machine for my y axis and it hold the head exactly where it stopped

This product has a nylon gear that breaks after some use this is my second motor all of the gears are metal except this one that is nylon type material designers need to rethink the gearbox to make it last

This motor has plenty of torque and runs great. I use it for my outside blinds.